Marantz ST-15S1 - Manual (Page 21)

18
ENGLISH
LAST FUNCTION MEMORY
• This unit is equipped with a last function memory which
stores the input and output setting conditions as they were
immediately before the power is switched off.
This function eliminates the need to perform complicated
resettings when the power is turned on.
• The unit is also equipped with a back-up memory.
This function provides approximately one week of memory
storage when the main unit’s power switch is off and with
the mains cord disconnected.
INITIALIZATION OF THE
MICROPROCESSOR
• When the indication of the display is not normal or when
the operation of the unit does not shows the reasonable
result, the initialization of the microprocessor is required
by the following procedure.
1. Press the POWER ON/OFF switch !0 to turn on the
power.
2. Press at the same time for MENU button !4 + BAND
SELECT button w and main cord pull out.
3. Main cord pull in.
4. During the initialization, it is converted to DAB Auto
Tuning state.
Note
• If step 3 does not work,start over from step 1.
• If the microprocessor has been initialized all the button
settings are reset to the default values (the values set
upon shipment from the factory).
OTHER OPERATION
DISPLAY DISPLAY
TUNED TUNED
STEREO STEREO
DOWN DOWN TUNING/PRESET TUNING/PRESET UP UP
RDS RDS
SECONDARY SECONDARY
DAB/FM/AM TUNER ST-15S1 DAB/FM/AM TUNER ST-15S1
BAND BAND SELECT SELECT
AUTO AUTO
TUNE TUNE
MENU MENU
ENTER ENTER
MEMO MEMO POWER ON/OFF POWER ON/OFF
!4 !0 w q
HOW TO OPERATE THE
ILLUMINATION LAMP
The illumination lamp has an always-ON mode and an
always-OFF mode. In the always-ON mode, the illumination
lamp turns ON/OFF in sync with the display.
1. With the illumination lamp lit, press and hold the
DISPLAY button q for 3 seconds or longer. The
illumination lamp goes out and the always-OFF mode is
engaged.
2. To cancel the always-OFF mode and turn the
illumination lamp ON, press and hold the
DISPLAY
button q for 3 seconds or longer.
ST-15S1N 01 Eng 06.8.29 2:48 PM ページ18