Marantz CD5005 - Manual (Page 42)

o Operations cannot be performed through the remote control unit
Symptom Cause / Solution Page
Operations cannot be
performed through the
remote control unit.
0
Batteries are worn out. Replace with new batteries. 5
0
Operate the remote control unit within a distance of about 7 m from this unit and at an angle of within 30°. 5
0
Remove any obstacle between this unit and the remote control unit. －
0
Insert the batteries in the proper direction, checking the q and w marks. 5
0
The set’s remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent bulb
light, etc.). Move the set to a place in which the remote control sensor will not be exposed to strong light.
－
0
When using a 3D video device, the remote control unit of this unit may not function due to effects of
infrared communications between units (such as TV and glasses for 3D viewing). In this case, adjust the
direction of units with the 3D communications function and their distance to ensure they do not affect
operations from the remote control unit of this unit.
－
0
Press the REMOTE MODE CD button to switch the remote control operating mode to “CD”. 11
0
When using this unit independently, set the switch to “INTERNAL”. 20
o Display on this unit shows nothing
Symptom Cause / Solution Page
Display is off.
0
Press the DIMMER button, and change the setting to anything other than off. 25
0
The display is switched off when the sound mode is set to “Audio EX 2”. 25
Contents Connections Playback Settings Tips Appendix
42 Front panel Display Rear panel Remote Index