LEI Electronics PT3802 Addendum - Manual (Page 3)

A3
Addendum for BIG BuTTon
emerGenCY PHone (PT3802)
Revised March 2015
3. PAIRING will display; use the UP or DOWN button until you see
DELETE? on the display.
4. Confirm your selection with the “OK” button.
5. The display will clear, the phone will announce “Deleted,” and the
display will return to the main screen.
6. Repair the pendants using the instructions below (#8 in the next
section).
To reset the phone memory (factory reset):
1. Remove the back-up batteries from the battery compartment.
2. Unplug the power adaptor, and wait 3-5 seconds.
3. Press and hold together the digits 1 , 2 and 3 keys.
4. Plug in the power adaptor while holding the 1 , 2 and 3 keys down.
5. The words Self Test Mode will appear on the LCD display.
6. Release the 1 , 2 and 3 keys, then reset the power again (unplug, wait 3-5
seconds, then plug again the power adaptor).
7. You must now pair the pendant to the phone.
8. To pair the pendant and the phone, follow these steps:
a. Press the
MENU
button and use the e or d buttons until REMOTE
PENDANT is shown.
b. Press the “OK” (CALL BACK/OK) button.
c. PAIRING will display; confirm your selection with the “OK” button.
d. The display will show PAIRING... for only 3 seconds.
e. Immediately press pendant key until you see PAIRED on the display.
NOTE: you may need to press and hold (1-2 seconds).
f. If no pendant was successfully paired, the display will show
PAIRING FAILURE .
g. Please repeat steps c. to e. until you have successfully paired the
pendant with the telephone.