La Crosse Technology WS-9625U-IT - Manual (Page 10)

9
SETTING UP:
When one sensor is to be used
1.
First, insert the batteries into the thermo-hygro sensor. (see “Install and replace
batteries in the thermo-hygro sensor “).
2. Immediately after and within 30 seconds, insert the batteries into Weather Station (see
“Install and replace batteries in the Weather Station”). Once the batteries are in place,
all segments of the LCD will light up briefly. Following the time as 12:00 and the "Oscar
Outlook" icon will be displayed. If these are not displayed after 60 seconds, remove the
batteries and wait for at least 10 seconds before reinserting them.
3. After inserting the batteries into the sensor, the Weather Station will start receiving data
from the sensor. The outdoor temperature and humidity and the signal reception icon
should then be displayed on the Weather Station. If this does not happen after 3 minutes,
the batteries will need to be removed from both units and reset from step 1.