InSinkErator LC-50 - Manual (Page 9)

9
Final Installation
Hang disposer by aligning 3 mounting tabs with
slide-up ramps on mounting ring.
21
Turn mounting ring until all 3 mounting tabs lock over
the ridges on the slide-up ramps.
22
You may need to trim tube for proper fit. Reconnect
plumbing (and dishwasher or direct water connection if
used). Make sure tailpipe mount is straight.
Insert stopper into sink opening. Fill sink with water,
then test for leaks.
23
24
Rotate the disposer around. Place the rubber gasket
on the end of the discharge tube and slide on the metal
flange from the reverse end. Place assembled discharge
tube in the tailpipe mount opening and secure with
screw provided.
20
Discharge Tube
Rubber Gasket
Screw
Metal Flange