Projector protocol input, Sequence – ILS ILS14A User Manual
Page 16
14
Projector Protocol Input
In order to input Projector protocol into Controller, PC RS-233 port should be connected to the Controller’s control RS-232 port.
Sequence
1.
First copy vb6ko.dll to the System32 folder, and install Vbruntimes.
(If it is not installed, you will get an error.)
2.
Next, execute Protocol Input and set COM PORT. (check your PC’s port number.)
3.
If you press the OPEN button, COM PORT opens. If the PORT setting is wrong, an error message is displayed.
In this case, open the device manager and recheck the port before resetting.
4.
Select your Projector.
5.
If you press the next protocol button, a matching LED flashes. While the protocol is being input, do not press
any other button, and wait until the LED stops flashing. If an other button is accidentally pressed, the next button
input can not be made. In this case, connect the power again and proceed with the input.
6.
After all input is completed, press CLOSE button to close COM PORT.