Hoefer SE300 miniVE - Manual (Page 26)

•
p18
The blot module
The Hoefer miniVE Blot Module, which can be
ordered separately, performs electrotransfers on
mini-format gels. Each module holds up to two
gels, 8.2 cm wide and up to 10.4 cm long. One
or two modules can be run at the same time.
Assembly

Prior to use, wash the tank and blot module with a
dilute solution of non-abrasive laboratory detergent.
Thoroughly rinse with water and distilled water.

Separate out two of the four strands of gaskets
included with each module.

Open the module by releasing both tabs.

Lay a gasket along the entire groove around three
sides of each cup half.
Avoid stretching or twisting the gasket; the length
should just fit. Gently press into place.
Each gasket fits into the groove
around three sides of each cup half.
Fig 14. Install a gasket into
each cup half.