HiTi P910L User Manual - Manual (Page 10)

Chapter 2. Installing and Set Up
7

USB Connector To be used to connect the USB cable.

Paper Setting Lamp
When setting the paper, insert the paper
until the lamp is lit. When the lamp
blinks, remove the paper until the lamp
goes off.

Open Guide Unit
Open the drawer unit when replacing
paper, or when performing maintenance.

Open Guide Lever
When open the open guide unit, hold
this lever.
Printer Status Lamps Name and Printer Status
Printer status lamp display ●:on, ○:off, ＊:flashing
LED Display
POWER MEDIA ERROR Description
○ ○ ○ The power of printer is off.
＊ ○ ○
The printer is initializing after turn on the
power
Thermal head is cooled/heated on printing.
● ○ ○
The printer is ready
If you leave the printer of ready state for 5
minutes, the printer goes into standby
mode automatically.
● ○
＊
The drawer unit is opened.
● ○ ●
Paper jam occurred.
The printer mechanical section is faulty.
Trouble of printer control board.
●
＊
● The ink ribbon loaded is not supported.
● ● ●
The paper is not set.
Out of the paper.
The ink ribbon is not loaded.
The ink ribbon is empty.
● ＊ ○
The printer is loading the paper or the ink
ribbon.