Fulgor Milano FDW9017 - Manual (Page 51)

INSTALLATION
519
1229
550
30-94
596
573
550
5
4
3
7
7
7
0
0
-8
0
0
30
7
1
0
1
9
5
4
4
4
49
7
4
0
8
6
4
-
9
1
2
1
3
3
-1
8
3
[mm]
*Remove locking nuts and any coasters for an
installed height of 860-864 mm.
**Door length.
It is important that you read through and follow the instructions
and directions below. Conduct installation and connection in
accordance with the separate installation instructions.
SAFETY INSTRUCTIONS
• Connections to electricity, water and drainage must be
performed by a qualified professional.
• Electrical, water and drainage installations must be carried out
by a qualified professional.
• Always follow applicable regulations for water, drainage and
electricity.
• An incorrect or flawed installation can result in higher
consumption of energy, water and detergent, which can result
in increased costs and poor dishwashing results. In order to
minimise noise it is important that you follow the instructions.
• Exercise caution during installation! Use protective gloves!
Always have someone assist you!
• Place a watertight protective tray on the floor under the
dishwasher to prevent damage from any water leaks.
• Before screwing the dishwasher into place, test the dishwasher
by running the Rinse & Hold programme. Check that the
dishwasher fills with water and drains. Check also that none of
the connections leak.
WARNING!
The ventilation opening in the lower part of the door must not
be blocked by a rug, carpet or similar furnishing.
WARNING!
Turn off the water supply when installing the dishwasher!
WARNING!
The plug must be disconnected or power to the socket turned
off while the work is carried out!
SETUP
• The recess and connection dimensions are included in the
separate installation instructions. Check that all dimensions are
correct before starting the installation.
• Make sure the area on which the dishwasher is to be installed
is firm. Adjust the adjustable feet so that the dishwasher is level.
Tighten the lock nuts.
DRAINAGE CONNECTION
See the separate installation instructions for all necessary
information.
The drainage hose may be extended by a maximum of 3 m (the
total length of the drainage hose must not exceed 4.5 m). Any
joins and connecting pipes must have an internal diameter of at
least 14 mm. However, the drainage hose should ideally be
replaced with a new hose without joins.
No part of the drainage hose may be more than 950 mm above
the bottom of the dishwasher. The hose must not be routed
directly to a floor drain or the like. In such cases, the hose can act
as a siphon and empty the dishwasher.
23