Fulgor Milano FDW9017 - Manual (Page 41)

START THE DISHWASHER
Press and hold Start/Stop until the display shows "Program started".
Close the door properly, otherwise the dishwasher will not start.
TIME REMAINING
Once you have selected a programme and options, the display
indicates how long the programme took the last time it was used.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature and other factors.
NOTE!
During the first run of each programme, the remaining time
displayed can be slightly misleading, as the dishwasher is estimating
the time. When you run the programme a second time, the
dishwasher will calculate the remaining time based on the
previous duration of the programme.
STATUS LIGHT (ILIGHT)
The status light at the bottom on the dishwasher provides
information by means of 3 different colours. Adjust the status light
so that it is seen clearly by pulling out or pushing in the transparent
plastic strip.
Status light
Blue
Load more. The programme has started, but you can still load
more dishes.
Red
Do not load. You should not load more dishes (risk of poorer
dishwashing result).
Flashing red
This indicates a fault. See further in the section Troubleshooting.
Green
Unload. The dishwashing programme is finished. Standby light for
two hours.
STOPPING OR CHANGING A PROGRAMME
If you want to change programme after starting the dishwasher,
open the door then press and hold Start/Stop for three seconds.
Add more detergent if the lid of the detergent dispenser has
opened. Then choose a new programme, press Start/Stop and
close the door.
DO YOU WANT TO ADD MORE DISHES?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door and the dishwasher continues the
programme.
IF THE DISHWASHER IS TURNED OFF USING
THE ON/LEFT-ON MODE BUTTON OR DUE TO
A POWER FAILURE
If the dishwashing programme was not finished, the interrupted
programme continues when power is restored.
NOTE!
During drying, the programme is interrupted if the power is cut
or the door is open for more than 2 minutes.
ONCE THE PROGRAM HAS FINISHED
Once the programme has finished and the door is opened "End"
appears on the display.
A buzzer also sounds at the end of the programme. See the section
Special settings, which describes how to change this function.
A status light also indicates the end of the programme. See the
section Status light (iLight) in the chapter Using the dishwasher.
Once the dishwasher has finished, it uses only standby power. Turn
off the water supply valve after each use.
13