Dish Network 112182 - Manual (Page 90)

Page 84
Chapter 4
Installation Instructions
2. Make sure that the remote control batteries are fresh, and are installed
properly. If needed, make sure that the remote is in SAT mode to control the
satellite receiver.
3. Turn ON the television and receiver.
4. Display the Point Dish and Signal Strength menu by pressing MENU and
and then 6-1-1 (unless the receiver already displays this menu).
5. If you Point Dish/Signal screen looks like the one on the left, continue to
step 6. If your Point Dish/Signal screen looks like the one on the right,
select
Peak Angles .
6. Enter your ZIP code in the ZIP Code field.
7. Select the Dish 500 option.
8. The menu displays the azimuth, elevation, and skew angles. Write down
these numbers in the blanks provided in the margin.
9. Select Cancel to exit out of this menu and return to the Point
Dish/Signal menu.
10. Go to Mounting the Dish on page 85.
Azimuth:
Elevation:
Skew: