Dish Network 112182 - Manual (Page 75)

Page 69
Control Other Devices with the Remote
Page 69
Set Up the Remote Control
You can set up the remote to control other devices using the device codes
listed on page 120.
1. Turn the device on. Use the device’s front panel buttons
or its remote control.
2. Find the brand name of the
device in the tables starting on
page 120.
If the brand isn’t listed, see Scan for
Device Codes on page 70.
3. Press and hold the mode
button until all the other mode
buttons light up, and then let
go of the button.
The mode button flashes.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you let
go, the TV mode light will flash.
4. For AUX mode only. Press 0
for a second TV, or 1 for a
second VCR, or 2 for a tuner,
amplifier, or cable box.
This step is for programming which
kind of device that should be
programmed in AUX mode. If
you’re not programming in AUX
mode, skip to step 5.
5. Enter one of the three-digit
device codes from the table
using the number buttons.
The three-digit device code should
be for the brand name of your device
that you found in step 2.
6. If you want to program
limited mode, press 1. If not,
skip to step 7.
See Limited Mode for more
information.
7. Press the POUND (#) button. If you entered the code correctly,
the mode button flashes three times.
8. Press the blank POWER
button to turn off the device. If
the device does not turn off,
go to step 10.
If the code works, the device should
turn off.
9. Turn the device back on and
try some other buttons to
make sure they work. If the
code works for other buttons,
stop here.
Sometimes the blank POWER
button works when other buttons
don’t.
10. If the code doesn’t work, redo
steps 3 through 9 with another
device code from the tables.
Try every code listed for you brand
until one works for your device.
11. If you can’t find a code that
works try, Scan for Device
Codes below.