Directed Electronics 50.7X - Manual (Page 31)

31 © 2008 Directed Electronics. All rights reserved.
still enabled).
You can still remote start the vehicle after the turbo timer has timed out
and shut off the vehicle. For safety reasons, if a door is opened or if the
alarm is triggered while you are away, the remote start exits the manual
transmission mode and does not remote start until the MTS sequence
is re-initiated.
Note: An optional push button can be hard wired to the (-) activation
input (H1/10) on the remote start. This allows the user to activate the
turbo timer without having to use the remote.
When the vehicle is running follow the procedures listed above, but
instead of pressing the remote, press the push button the appropriate
number of times to activate the remote start (factory setting is for 1
pulse). The remote emits the remote start confirmation tone, after which
you can turn off the ignition and exit the vehicle. The car remains run-
ning for the pre-programmed amount of time.
Runtime check
Command
: While the remote start is running, press
AUX
two-times,
and then Hold for 1.5 seconds.
Feedback
: Text reads runtime and displays time left
Notes
: This feature is only available on the 2way remote.
Runtime reset
Command
: While the remote start is running, press
AUX
one-time and
then
AUX
.
Feedback
: Remote start ON tones.
Notes
: Re-starts the remote start runtime counter if remote start
is active. Note: If remote start is not active, the 2-WAY