Using the system, Details – Directed Electronics 50.7X User Manual

Page 17

Using the system

Please note the screen shot to the right of a feature indicates what the
display looks like when this feature is activated.

A U

Arm

Command

Press one time to Arm

Feedback

Lock Icon will appear, and one beep

from remote

Notes

Press/hold for 1.5 seconds to Arm

the system and then activate the

Panic output

Details

: The siren in the vehicle will “chirp” once and the parking lights

will flash once. If the power door locks have been connected, the
doors will lock. The system will automatically check for errors when it
arms. The 2-way remote will “chirp” once and the lock icon appear to
confirm arming. If no arm confirmation is received, the remote will give
the Out-Of-Range signal.

If errors are found when arming:
If an alarm trigger zone – such as a door, the trunk, the hood, or a
sensor, was active at the time of arming, the system will “bypass”, or
ignore, this trigger zone. This allows the system to continue to protect
your vehicle using the remaining trigger zones.
You are notified of this active zone immediately after arming the system.
The siren in the vehicle will “chirp” again after arming. The Status LED
indicator in the vehicle will blink in a pattern to indicate the active
zone number error which was found (See Table of Zones). The 2-way
remote control will sound a short “error” tone and the text will display
the active zone..