Bronkhorst BRIGHT (V2.00 and higher) - Manual (Page 8)

4 | CONNECTING
4 Connecting
! Do not apply pressure until electrical connections are made.
!
When providing your own power supply, be sure that voltage and current rating are according to the
specifications of the instrument(s). Cable wire diameters should be sufficient to carry the supply current and
voltage losses must be kept as low as possible.
!
Bronkhorst High-Tech B.V. recommends using their standard cables. These cables have the right connectors
and if loose ends are used, these will be marked to prevent wrong connection.
The hook-up diagrams are available at the download section of our website: http://www.bronkhorst.com
!
Before switching on power check if all connections have been made according to the hook-up diagram which
belongs to the instrument.
! Turn on power and allow at least 30 minutes to warm up and stabilize the connected instrument.
! When the T-part is connected, other RS232 communication is disabled.
9.17.048 Page 8