Bronkhorst BRIGHT (V2.00 and higher) - Manual (Page 15)

5 | USER INTERFACE
The instrument directly connected with the BRIGHT will be
indicated as ‘local’. Other instruments will be indicated
with their node address.
Press
or to search another instrument on the bus.
While the message “search” is displayed, the BRIGHT is
searching for a valid node address and it will not show any
specific instrument info till an active node is found.
When an active node address is found, the BRIGHT will
show the corresponding USERTAG or Serial Number in the
topline. It will also show the actual measure and, if applied,
the actual setpoint.
Press to select this instrument to be operated by the
BRIGHT or press to return to the previous selected
instrument.
SET
CANCEL
9.17.048 Page 15