6 solenoid connection, Steps, Attach eachv lead with two plugs to solenoid – Bluelab Dosetronic Solenoid Kit User Manual
Page 14
10
Version S1.3 : 260511
Bluelab Dosetr
onic Solenoid Kit
Bluelab Corporation Limited
Po
w
e
r
pH
Dosing system
Temperature
Conductivity
pH ATC
Alarm
Power Input
DC INPUT: 5V --- 3A
Temperature
Power Out
Temperature
Power In
pH
(lower or raise)
Nutrient B
Nutrient A
Power
24V AC
Steps
1. Plug main solenoid lead into Dosetronic case.
2. Each pair of connectors is labelled for identifi cation.
3. The main lead has three leads that branch from
it. Each lead has two plugs, attach both of these
to the top two connectors of each solenoid. There
is no connector for the bottom terminal (polarity
is not important).
4. Connect the solenoid power source
(24V AC) to the solenoid leads.
Run lead sets from the solenoids
around the back of the stock
solution tanks as pictured
2.6 Solenoid Connection
2
Attach eachv lead with two
plugs to solenoid
A
A