Dish Network DuoDVR ViP 722_TOC - Manual (Page 27)

Remote Controls
81
The Recover Button
Programming to Control a Second Satellite Receiver
If you have another DISH Network satellite receiver installed, you can use this remote in AUX
mode to control it along with your new receiver. When you program the remote to control this other
receiver, the remote will send out IR and UHF (not UHF Pro) signals to the receiver. You can
program the remote to control any other DISH Network satellite receiver, except for following:
• TV2 on DISH 322, ViP222, ViP622 DVR, ViP722 DVR, DISH Player-DVR 522, 625, and 942
• DishPlayer 7100/7200
1. Turn on the other receiver and display the System Info screen.
Write down the receiver’s address:
2. Using the new remote control, press and hold AUX until all the other mode buttons light up,
and then release the button. AUX flashes.
3. Press the 3 button.
4. Use the NUMBER PAD to enter the address you wrote in step 1.
5. Press POUND (#). AUX blinks three times.
6. Press RECORD to make sure the address in the remote matches the address on the other
receiver.
The Recover Button
Use RECOVER if you have a snowy, blue, or black screen on your TV and cannot get the picture
back from your satellite receiver. When you press RECOVER as described, the remote control
sends commands to your TV to change channels or video inputs to get back to watching satellite
programming. This procedure works only if you have accidentally changed the TV channel or
video input. It does not recover lost satellite signal (See Troubleshooting on page 120 for more
information).
Note: The remote must be programmed to control the TV (and VCR, if applicable) for RECOVER
to work as described.
Note: RECOVER will first try to tune your TV to channel 3, then channel 4, and then other video
inputs with each press of RECOVER. You may need to press RECOVER up to 30 times to recover
1
2
3
5
4
Press and hold the
AUX Mode buttton until all
Mode butttons light up
(Button will Flash)
Display System Information
screen and note the
Remote Control Address
Press the
3 button
AUX
Enter remote
address from step
one
Press POUND
(AUX button
will flash 3 times)
6
Press
RECORD
2
Next
System Info Mon, October 18
Copyright 2005, EchoStar Technologies Corp. All Rights Reserved.
Details Done
a
d e
g
h
c b
f
i j
Status: Good 0
0
DISH Player-DVR 522
Software: L236 R00 0000 0000-01
S00 0000 0000-01
Satellite:
Signal:
119 110 148
Device: DP34, Feed(1), Feed(2), Feed(3)
Remote Addrs.
TV Out
UHF 3 5 Remote Addrs.
TV Out
UHF 3 5 1 2