Artesyn ViewCheck on ATCA-9405 Installation and Use (May 2014) - Manual (Page 86)

Commands Execution
ViewCheck on ATCA-9405 Installation and Use (6806800S51C) 86
The functionality and access methods provided are briefly described in this section.
Note: Currently monitors are supported only on Service Processor.
5.5.1 Monitoring HW Device Status
In Service Monitoring also periodically polls for various devices status on the blade. These are
 Network Devices Counters Statistics
 Network Devices Error Statistics
Each of the above is identified by a unique Monitor ID. For more information on Monitor ID,
refer
Monitor ID on page 18 .
The Default Poll Interval for monitoring each of the Monitor ID is set to 10 Seconds.
Commands are provided to alter the default settings.
For more information on the commands provided for InService Monitoring, refer Monitoring
Commands on page 76 .
The following table provides list of Monitor IDs and Device Instances for each of the Monitors
being monitored on ATCA-9405.
Table 5-23 Monitors
Monitor Description
Monitor
ID
Valid Device Instances Remarks
Network Errors 1020 eth0(62),eth1(63),eth2(
64) Monitors the various Error
counters for each of the Network
Device Instances and provides an
error counter exceeds the rate of
change.
Network Counters 1021 eth0(62),eth1(63),eth2(
64) Monitors the various counters for
each of the Network Device
Instances