ZENNER multipulse - Manual (Page 6)

Subject to modifications and errors excepted.
Any liability for misprints excluded. SAP124288_150601_EN
Installation instructions
Safety instructions
The installation has to be done by qualified per-
sonnel. Read the instructions carefully right up to
the end before starting to mount the device.
The current laws and regulations regarding the
installation have to be observed
At devices with communication interfaces or
mains supply the general technical rules and the
correspondent regulations have to be followed.
General Information
Take care of:
■
the display of the module must readable at all
times,
■
to avoid malfunctions due to other interfer-
ences do not install fluorescent lamps, switch
cabinets or electric devices such as motors or
pumps in the immediate vicinity of the module
(minimum distance 1 m),
■
the ambient temperature must not exceed
55°C,
■
the pulse value of the meter must correspond
with the one from the module.
The module has 7 cable glands for wires with a
diameter between 4,2 and 10 mm. Keep unused
glands closed. multipulse resp. multilog is deliv-
ered ready for operation. It does not need any set-
tings or adjusting.
ZENNER International GmbH & Co. KG
Römerstadt 6
D-66121 Saarbrücken
Telephone +49 681 99 676-30
Telefax
+49 681 99 676-3100
E-Mail [email protected]
Internet www.zenner.com
6