wePresent WiPG-2000 - Manual (Page 60)

60
encryption mode you selected. (If the length of the key entered is not
sufficient or too long, a warning message will pop up.)
Note: The Encryption and Key information must be consistent to the exiting
AP configuration.
: Press “Apply” button after configuration, and follow the reboot instruction
when applicable.
: Press button to abort action.
10.9 SNMP Setup
Enable or disable SNMP V3 service
User Name: configure the user name to manage this device through SNMP
Auth Password: configure the Auth password
Priv Password: configure the Priv password
Trap IP: configure the trap receiver IP
: Press “Apply” button after configuration, and follow the reboot instruction
when applicable.