Brennenstuhl Power LED Lamp L2705 IP44 27x0,5W 1080lm Energy efficiency class A - Manual (Page 8)

8 GB
LED-light
(Models L2705 and L2705 PIR)
Parts description
1 Screw for connector box
2 Screw terminal
3 Release button
4 Mounting plate
5 Screws for mounting plate
6 Cable feed-through
7 Wall plug
Safety notes
Note: Please ensure you read the following notes
before installing the light. Make sure the power is
switched off, before you install the light. The instal-
lation of the light should only be carried out by a
qualified expert.
This light may not be operated
unless all sealing rings are located properly!
LED-lights are extremely bright. Under no cir-
cumstances look into the light beam of the LED
lights, as this may cause permanent damage to
your eyes.
1 m
FIRE HAZARD! Fit the light so that it
is at least 1 m away from the material
being illuminated. Excessive heat can
result in a fire.
If the glass is broken, it must be replaced
with a new original Brennenstuhl pro-
tective glass before further use.
RISK OF INJURY FROM BURNS! Ensure the
lamp has been switched off and allowed to cool
before you touch it.
Technical data
Voltage: 220 - 240 V~50 / 60 Hz
Wattage: 27 x 0,5 W LED
Weatherproof: IP44
Protection: Class I
This luminaire is only intended for normal use, must
not be used for rough service.
Only for model L2705 PIR:
Detection area
movement detector: 130° and max. 10 metres,
adjustable
Time span: adjustable from 10 (±5) sec-
onds to 4 (±1) minutes
Installation
Note: The light must be fitted to a dry, sturdy and
stable surface according to the notes in Fig. B.
Ideally the LED light should be fitted at a height
of 1.8 bis 2.5 metres off the ground (see Fig. B).
Only for model L2705 PIR:
The movement detector should not be directed
towards heat sources, such as barbecues, air
condition units, other outside lights, passing
cars or ventilation openings, to avoid annoying
unwanted activation.
The movement detector should not be fitted in
an area with strong electromagnetic interfer-
ences, to avoid annoying unwanted activation.
Do not point the appliance towards reflective
surfaces such as smooth white walls, swimming
pools, etc. The technical specifications for the
detection area (max. 10 metres at 130°) may
vary depending on fitting height and place.
The detection area of the appliance can also
differ with changing temperature. Before you
choose where to fit the appliance, you should
take into consideration that movements perpen-
dicular to the movement detector are more ef-
fective than movements straight towards or
LED-Leuchte_Content_L2705–2705 PIR_EU.indd 8 07.01.13 08:46