Denon AVR-5700 - Manual (Page 39)

39
After starting playback
[1] Adjusting the sound quality (tone)
The tone control function will not work in the direct or Home THX
Cinema mode.
1 Adjust the bass sound to the desired level using the BASS
adjustment control, the treble sound using the TREBLE
adjustment control.
BASS
• To increase the bass or treble: Turn the control clockwise.
(The bass or treble sound can be increased to up to +12
dB in steps of 2 dB.)
• To decrease the bass or treble: Turn the control clockwise.
(The bass or treble sound can be decreased to up to –12
dB in steps of 2 dB.)
2 If you do not want the bass and treble
to be adjusted, turn on the tone defeat
mode.
2
The signals do not pass through the
bass and treble adjustment circuits,
providing higher quality sound.
[3] Turning the sound off temporarily (muting)
1 Use this to turn off the audio output
temporarily.
Press the MUTING button.
2
Cancelling MUTING mode.
Press the MUTING button again.
[4] Combining the currently playing sound with the desired image
1 Simulcast playback
Use this switch to monitor a video
source other than the audio source.
Press the VIDEO SELECT button
repeatedly until the desired source
appears on the display.
2
Cancelling simulcast playback.
[5] Checking the currently playing program source, etc.
1 On screen display
• Each time an operation is performed, a
description of that operation appears
on the display connected to the unit’s
VIDEO MONITOR OUT jack. Also, the
unit’s operating status can be checked
during playback by pressing the remote
control unit’s ON SCREEN button.
Such information as the position of the
input selector and the surround
parameter settings is output in
sequence.
RETURN
ON SCREEN
MUTING
[2] Listening over headphones
Plug the headphones’ plug into the jack.
2 Connect the headphones to the PHONES jack.
The pre-out output (including the speaker output) is automatically
turned off when headphones are connected.
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
2 1
HOME THX CINEMA DOLBY / DTS SURROUND DIRECT
DSP SIMULATION 5CH STEREO STEREO
INPUT MODE ANALOG EXT.IN
MUTING
MASTER VOL.
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD MD LOCK DECK 1
1
TUNING
BAND TITLE MENU/GUIDE
MODE
MEMORY
USE/LEARN T.TONE MULTI DVD SET UP
RETURN
PANEL
DISPLAY
ON SCREEN
SYSTEM SETUP SURROUND PARAMETER
CH SELECT
SELECT
ENTER
1
1
Front panel display
• Descriptions of the unit’s
operations are also
displayed on the front
panel display. In addition,
the display can be
switched to check the
unit’s operating status
while playing a source by
pressing the PANEL
button.
TONE
DEFEAT
VIDEO
SELECT
(Remote control unit)
Using the dimmer function
• Use this to change the brightness of the display.
The display brightness changes in four steps
(bright, medium, dim and off) by pressing the
remote control unit’s DIMMER button
repeatedly.
2
The brightness changes in 3 steps each time the
button is pressed, and finally the display turns
off.
DIMMER
PANEL
(Main unit)
TREBLE
1
PANEL
DISPLAY
• Select “SOURCE” using the video select button.
• Switch the program source to the component connected
to the video input.
Lightly press on the bottom of
the door to open it.