Dish Network Duo ViP 222 - Manual (Page 23)

Satellite Receiver
15
Remote Controls
Remote Control Batteries
The remote control comes with AAA batteries. When you replace old
batteries, you should replace all of the batteries. Use batteries of the same
kind, for example, alkaline or carbon zinc. Don’t mix batteries of different
kinds. Alkaline batteries last longer.
1
Press down on the top of the battery cover and slide the cover off.
2
Take out all of the old batteries.
3
Put the new batteries in. Make sure you match the plus (“+”) ends with the
plus markings on the battery case.
4
Slide the cover back into place.
Low Battery Warning
When you see a low-battery warning message on your screen below the Program Banner,
the batteries in your remote control are weak and need to be replaced.
Attach the Remote Antenna
Attach the remote control antenna to the receiver's back panel R EMOTE A NTENNA input
jack so you can use your UHF Pro Remote Control 2. Without the remote control antenna,
you cannot use this remote to control the receiver. See Adjusting the Remote Antenna on
page 60 for more detailed information about improving the performance of your UHF
remote control.