Dakota Digital MCL-3000 User Manual
Page 7
Manual # 650339
Locking tab on terminals Using a small allen/pick release the locking tab
Push gently on the tab to release pin Remove the pin from the connector
Oil Temp Sensor Plug Connections
GAUGE SETUP
The oil temp gauge has a user selectable high temperature warning point that can be set so the
gauge will flash the reading when the temp is met or exceeded. The gauge will only read correctly with
the supplied sender.
The GREEN switch input wire, in the two pin connector, is used to enter setup. If you are only
installing one or a couple Dakota Digital MCL-3K gauges set up may seem a little strange since they are
designed to work as a set, however you’ll simply cycle through a few screens to get to the desired gauge.
The table below shows what will be on the gauge with each button press, or tapping the GREEN wire
high +12V.