Pontiac 2004 Grand Prix - Manual (Page 81)

Canadian Owners: If you lose or damage your keys,
only a GM dealer can service PASS-Key
® III to
have new keys made. To program additional keys,
you will need two current driver’s keys. You must add a
step to the following procedure. After Step 2, repeat
Steps 1 and 2 with the second current driver’s key.
Then continue with Step 3.
To program the new key do the following:
1. Verify that the new key has PK3 stamped on it.
2. Insert the master key in the ignition and start
the engine. If the engine will not start, see your
dealer for service.
3. After the engine has started, turn the key to OFF,
and remove the key.
4. Insert the key to be programmed and turn it to RUN
within five seconds of removing the original key.
5. The SECURITY DISABLED DUE TO THEFT
SYSTEM warning message on the DIC will turn off,
once the key has been programmed. It may not
be apparent that the SECURITY DISABLED DUE
TO THEFT SYSTEM warning message went on due
to how quickly the key is programmed.
6. Repeat Steps 1 through 5 if additional keys are to
be programmed.
If you are ever driving and the SECURITY DISABLED
DUE TO THEFT SYSTEM warning message on the DIC
comes on and stays on, you will be able to restart
your engine if you turn it off. Your PASS-Key
® III system,
however, is not working properly and must be serviced
by your dealer. Your vehicle is not protected by the
PASS-Key
® III system at this time.
If you lose or damage your PASS-Key ® III key, see your
dealer or a locksmith who can service PASS-Key ® III
to have a new key made.
2-17