DoubleSight Displays DS-15xx - Manual (Page 22)

User’s Manual
14 Setting Up Your Monitor
NOTE
If your computer does not specify VGA 1 and 2, you can change the
order later using your computer display setting or monitor On-Screen
Display setting. Refer to the “Setting Up Computer Display
Properties” of this section and “Source Select” of “Key Function
Controls” section of this User’s Manual.
If your computer has only one VGA port, you will need to install an
additional graphics card to support a dual monitor. Refer to the
“Troubleshooting & Support” section of this User’s Manual for details.
Additionally, DoubleSight may be connected to two separate
computers by attaching one VGA cable to each computer.
With the two VGA signal cables connected to the computer, turn on
the computer. Press the power switch on the monitor. The display
should appear.
NOTE
If this is the first time for a dual monitor configuration with your
computer, you may need to set up your computer display properties.
Refer to the next section. If no display appears even after setting up
your computer display properties, refer to the “Warning Messages
and Troubleshooting Checklist” in the “Troubleshooting & Support”
section of this User’s Manual.
Computer2
Computer1