Imaxrc B610-PRO User Manual
Page 9
Pb(lead-sulphuric acid)battery program
15
16
This is programmed for charging pb(lead-acid)battery with nominal voltage from 2 to
24v.Pb batteries are totally different from NiCd or NiMH batteries.They can only deliver
relatively lower current compare to their capacity,and similar restrictions definitely
apply to charge.So the optimal charge current will be 1/10 of the capacity.Pb batteries
must not be charged rapidly.Always follow the instruction is supplied by the
manufacturer of battery.
When you are willing to alter the parameter value in the program,press Start key to
make it blink then change the value with INC or DEC key.The value will be stored by
pressing Strt key once.
Set up the charge current on the left and the
nominal voltage of the battery on the right.The
charge current ranges from 0.1 to 10.0A and the
voltage should be matched with the battery being
charged.
Start the charge process by pressing Start key for
more than 3 seconds.
The screen displays the state of charging
process.To stop charging forcibly,press Batt type
key once.
The audible sound indicates you at the end of
process.
Charging pb battery
Save Data program
Discharging pb battery
Set discharge current on the left and final voltage
on the right.The discharge current ranges from
0.1 to 5.0A.
To start the process,press Start key for more than
3 seconds.
The sereen displays the current state of
discharge.You can later the discharge current by
pressing Start key during the process.Once you
change the current value,store it by pressing Start
buttoon again.
To stop discharging press Batt type key once.The
audible sound indicates you at the end of process.
Save Data program
B6 10 Pro has a data storage and load program for your convenience.This feature can
store up to 10 battery data by number that represent the individual specification of
batteries you are using.They can be called back for the process of charging or
discharging without setting up the program again.To set up the parameter value in the
rogram,press Start/Enter key to make it blink then change the value with INC> or <
DEC key.
The parameter value setting up in this screen
does not affect charge or discharge process.They
only represent the specification of the battery.The
following screens will automatically be displayed
exactly matched with the battery type you set
up.The example shows the battery pack of
NiMH,12 cells and 3000mAh of capacity.
Set up the charge current for manual charge
mode,or the current limit for automatic charge
mode.Each mode can be switched by pressing
INC > and
the current field is blinking.
Setting up discharge current and final voltage.
Setting up the sequence of charge and
discharge,and the cycling number.
Saving the data.
NiMH DISCHARGE*
4.0A 11.0V
NiMH CYCLE *
DCHG>CHG 3
SAVE ...
PROGRAM SELECT
SAVE DATA
Pb CHARGE
4.0A 12.0V(6P)
Pb-6 4.0A 12.59V
CHG 022:43 00682
Pb DISCHARGE
4.0A 12.0V(6P)
Pb-6 4.0A 7.42V
DSC 022:43 00682
battery
type
elaopsed
time
charge
current
battery
capacity
charged
capacity
battery
type
elaopsed
time
charge
current
battery
capacity
charged
capacity
SAVE [01] NiMH
14.4V 3000mAh
NiMH CHARGE At*
CUR LIMIT 5.0A
voltage
data
number
type of
battery
capacity