Hall Research VSA-HA-DP - Manual (Page 5)

3
© Copyright 2014. Hall Research, Inc.
All rights reserved.
HDMI wallplate with Audio Extraction
3.0 Installation
The VSA-HA-DP is a modular wall plate that sends HDMI and Audio to the VSA-51-R
receiver via (2) Cat5e/6 cables. This wall plate is one part of a larger system with
multiple capabilities. Simply plug the A and B RJ45 outputs on the rear of the wall-plate to
the corresponding inputs on the receiver. Make sure to plug A to A and B to B. The wall
plate will not work if the UTP cables are crossed and damage may occur.
1080i/720p signals can be extended to 170ft, while1080p signals can be extended up to
130 ft. For distances of 100 ft or beyond 23 gauge Cat6 cable is recommended.
Make sure the receiver is powered off.
Connect the VSA-HA-DP to the VSA-51 Receiver using (2) Cat5e/6 cables
Make sure the HDMI output of the VSA-51 Receiver is plugged into a projector or display
Power up the VSA-51 Receiver. The power light on the wall plate illuminates
Connect any HDMI or DVI video source to the VSA-HA-DP video input
Connect an external audio source to the VSA-HA-DP 3.5mm audio if desired