How to use your appliance – Glow-worm Ultracom2 35 Store User Manual
Page 14
0020112186_PROTO_10 - 01/11 - Glow-worm
- 12 -
HOW TO USE YOUR APPLIANCE
Heating
+
domestic hot
water
Heating only
Domestic Hot
water only
i
IMPORTANT: When neither of
the symbols are displayed,
the boiler is in frost-protection
mode.
8.5.2 Adjusting the domestic hot water
temperature
• Press the buttons or of the function
to adjust the temperature of domestic
hot water.
Temperature of the water
(°C)
min.
45
recommended
50
max.
65
Keep hot facility function:
- Hold down the buttons
and of the function to
deactivate the
function.
- When
is displayed the keep hot
facility is deactivated
- When
is not displayed the keep
hot facility is activated
- The
mode corresponds to a
minimum temperature for water
storage in the tank. When it is reached,
reheating starts automatically. This
mode is used to reduce the number of
times the tank is heated and thus the
number of boiler start-ups.
i
IMPORTANT:
The Climapro
2
RF
can be used to time the keep hot
facility.
8.5.3 Adjustment for the water
temperature in the heating circuit
• Press the buttons or of the function
to adjust the temperature of the
water in the heating circuit.
Temperature of the water
(°C)
min.
10
recommended
50
max.
Pre-set by the installer
NOTE: If a Glow-worm outdoor sensor or
Glow-worm intelligent controls are fitted,
the temperature of the water in the heating
circuit is calculated by the boiler.
- It is neither necessary nor possible to
adjust it manually.
- Press briefly the buttons or of
the function show the value of this
temperature.