Ditch Witch MV800 - Manual (Page 78)

MV800 Operator’s Manual
Service - 77
50 Hour
CMW
®
Lube Blower Bearings
Wipe two zerks clean and lube every 50 hours
with HTG. Inject grease into zerk until clean
grease comes out of relief fittings.
Change Water Pump Oil
Change oil after the first 50 hours of operation
and every 100 hours thereafter. Change oil more
frequently if working in dusty conditions.
• Drain at drain plug (3) while oil is warm.
• Add NDO at fill (1) until oil is at halfway mark
on sight glass (2).
Debris Tank
Lube Tank Pivot Pins
Lube two pins every 50 hours with MPG.
NOTICE: Do not inject grease too quickly.
Drive shaft seal damage could occur.