Directed Electronics G4203P - Manual (Page 11)

11 © 2008 Directed Electronics. All rights reserved.
To shut off the remote start:
While the vehicle is remote started press and hold the button on the
remote for 3 seconds. The remote plays the remote start shut off tones
and the orange LED flashes 1 time. The vehicle shuts down from the
remote start mode.
Once the remote start is on, when you are ready to drive the vehicle:
Insert the ignition key and turn it to the ON 1.
(not the START) position.
Press the brake pedal. The vehicle stays running and is ready to
2.
drive.
Note:
If the brake pedal is pressed before the key is in the ON position,
the engine shuts down.
While the vehicle is running during remote start operation, the system
monitors the vehicle and automatically shuts down the engine if the
system receives any of the following shut-down inputs:
The brake pedal is pressed. •
The hood is opened. •
The shutdown toggle switch is put into the ON position. •
The pre-programmed run time has elapsed. •
The single button is pressed and held for 3 seconds. •