Aiphone IP MULTIFUNCTIONAL MASTER STATION AN-8500MS - Manual (Page 4)

7. WIRING
Power supply connection
The following 2 methods are available for
supplying power to the station.
• From a DC 12 V AC adapter
• From an IEEE802.3af compliant PoE
switching hub
(For connection, refer to the instruction
manual supplied with the switching hub
AC adapter connection
Connect the AC adapter*
Install the supplied ferrite /
clamp on the AC adapter /
cable by winding the f
cable around the ferrite »
clamp once.
Use the AC adapter AD-121 OP (optional) or the equivalent.
As for the usable adapter, consult the AlPHONE sales
office.
External speaker connection
■
AN-8500MS rear
□
J
c _______ ______ i
Press down the desired push­
in terminal button with a tip of
standard driver, and insert
the cable securely.
' Applicable cables are as follows.
Conductor diameter:
00.4- 1.3 mm (AWG16-26), Solid wire
00.7- 1.4 mm (AWG16-22), Stranded wire
' When using the external speaker,
set the internal/external speaker
switch on the bottom to the EXT.
SP position.
Use a UTP category 5 straight-
through cable with an RJ-45
connector for this connection.
To network
Can be connected to a network of 10BASE-
T/100BASE-TX in auto-sensing.
Use a UTP category 5 straight-through cable
with an RJ-45 connector for this connection.
8. ACCESSORY 8. OPTIONAL PRODUCTS
CD* ..............
Ferrite clamp AC adapter: AD-1210P
Wall mounting bracket: YC-280
Contains the AN-8000 setting software program and
the AN-8000 series instruction manual. The Setup
Launcher is automatically started when the supplied
CD-ROM is inserted into the PC's drive.
Note
If your PC's CD drive is not compatible with the
AutoRun function, the setup guide is not automatically
started even when the CD is inserted. Use either
"Explorer" or "My Computer" to execute the following
files, or use [Start -♦ Run] in the Task Bar and enter
the following command.
\index.html
For example, when placing the CD in the "d" drive,
-*■ d:\index.html
-----------------Version update information------------------
Please contact to the AlPHONE sales office to obtain
the up-to-date version for firmware, software and the
instruction manuals.
The software version number can be confirmed using
the Help menu.
The current firmware version can be confirmed on the
system management screen displayed when the
browser establishes the connection to the station.
The instruction manual version number can be
confirmed by checking the preparation date (year and
month) shown at the lower right corner of the last
page.
Example: Prepared in July 2006: 200607