After use, Turn off the machine at the on/off button, Safety – ASKO 11505 User Manual
Page 9: If the machine won’t work, Problem response
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

9. After use:
Turn off the machine at the
On/Off button.
NB! Don't close the door after
using the machine: leave it ajar.
Safety
The machine incorporates a door safety
switch which prevents it from being
started if the door is open. The door is
also interlocked to prevent it from being
opened when the machine is running or
when it has stopped with water in.
If the machine won’t work
Problem
Response
The door will not open.
1. Check that the main On/Off switch is turned on.
2. If the indicater lamp is not lit, there is no power supply. Check the plug and
fuses. The door cannot be opened normally if there is no power supply.
3. If the door cannot be opened in the normal manner, it can be opened as
follows. Insert a small screwdriver in the hole to the left of the door and
press the door catch upwards to release the door.
If the door still cannot be opened in the normal way afterwards, call a sen/ice
engineer.
The machine does not fill with water
when started.
1. Is the tap In the supply line open?
2. Is the strainer in the inlet connection blocked? Unscrew the hose and check.
Remember to turn off the water supply first.
The machine does not start when the
program knob is turned to the starting
position.
1. Is the door properly closed? Press it shut firmly - don't slam it.
2. Is the main On/Off switch turned on?
3. Has the power supply failed? Check the plug and fuses.
The machine wiil not spin.
1. Is the pump or outlet hose blocked? Clean if necessary, as described on
page 8.
2. Has the power supply failed? Check the plug and fuses.
3. The machine will make up to 30 attempts to start, redistributing the washing
if the drum is out of balance. After that, it passes on to the next stage of the
program.
A lot of foam in the final rinse water, or
water ieft in the machine after spinning
and pumping out.
1. Is anything blocking the outlet hqse? A button or a coin can do so. Make
sure that no part of the hose (including any joints) is less than 15 mm in
diameter.
2. Is the pump blocked? Clean it as described on page 8.
3. Is the outlet hose kinked?
9