ASKO 11505 - Manual (Page 11)

Electrical installation
The machine is delivered ready-fitted with a plug, and is
intended for connection to an Asko Dryer. The Asko Dryer is
equipped with a matching receptical. The plug supplied with
the washer can only be used with an Asko Dryer. If the
washer is used seperately or with another dryer, it must be on
its own separate 220 V single phase circuit.
If the machine is to be used in a wet area, the supply must be
protected by a residual current device.
Connection to a permanently wired supply point must be
made only by a qualified electrician.
As supplied: 208-240 V, 60 Hz
3265 W heater rating,
15 A fuse required
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk
of electric shock by providing a path of least resistance for electric current. This appliance is equipped with
a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an
appropriate outlet that is properly Installed and grounded in accordance with all local codes and ordinances.
WARNING - Improper connection of the equipment-grounding conductor can resuit in a risk of electric
shock. Check with a quaiified electrician or senriceman if you are in doubt as to whether the appliance is
property grounded.
Do not modify the piug provided with the appliance - if it will not fit the outlet, have a proper outlet Installed
by a qualified electrician.
Water supply connection
The water supply connections must be made by
a person having the necessary competence.
Water pressure must be in the range
15-146 PSI.
A tap must be fitted in the supply pipe for the
hose.
If a new supply pipe has been installed for the
machine, it should be flushed through thoroughly
in order to remove any particles of dirt which
might otherwise block the strainer in the water
inlet of the machine.
Drain outlet connection
The machine is supplied with the outlet hose
ready fitted. The hose should be hung over a
suitable sink edge or drain pipe at a height of
15 3/4"-35 1/2“ above the floor: the lower
height is preferable. Make sure that the hose
is not kinked.
NB! If the hose is extended, the internal
diameter of the coupling must not be less
than 1/2“.
Cold water supply
15 3 / 4"-35 1 / 2 "
11