Evenflo Symphony 65 - Manual (Page 20)

For
ward-facing
Recline Positions Rear-facing use ONLY 1 Forward-facing 10 - 18 kg (22-40 lbs) when using Harness Straps 3 2 Forward-facing 10 - 29.4 kg (22 - 65 lbs) when using Harness Straps AND in Booster Mode 18 - 49.8 kg (40 - 110 lbs) Arrow must be level with ground when child restraint is used rear-facing.
Lower Anchor Bar Lower Anchor Bar
Near Side
3. Attach lower anchor connectors.
Push a lower anchor connector onto each vehicle
lower anchor bar.
Note: You may need to vary the angle of the lower an-
chor connectors, as shown above, to attach to the lower
anchor bar. Also, make sure the lower anchor connector
assembly is in the forward-facing belt path (p. 33).
36
Forward-facing Installation with Lower
Anchor Connectors
Far Side
IMPORTANT: Make sure both SureLatch connectors or Quick
Connectors are facing upward and the straps are not twisted.
Strap
Correct Incorrect
SureLatch
Quick Connector
4. Ensure child restraint is secure.
To secure a child restraint that has SureLatch connec-
tors, go to Step 4a. To secure a child restraint that has
Quick Connectors, go to Step 4b.
37
Forward-facing Installation with Lower
Anchor Connectors
4a. Secure the child
restraint –
SureLatch Con-
nector.
Using your full weight,
push the child restraint
firmly into the vehicle
seat, as shown, to set it
in place.
buckl e storag e
Forward-facing
Belt Path
Recline Positions Rear-facing use ONLY 1 Forward-facing 10 - 18 kg (22-40 lbs) when using Harness Straps 3 2 Forward-facing 10 - 29.4 kg (22 - 65 lbs) when using Harness Straps AND in Booster Mode 18 - 49.8 kg (40 - 110 lbs) Arrow must be level with ground when child restraint is used rear-facing.
buckle storage
buckle storage Forward-facing
Belt Path
buckle storage Note: In some vehicles, you
may need to prop up the
SureLatch connector
while
pushing downward on the seat
to secure it tightly. Repeat for
the other SureLatch connector.
4b. Secure the child
restraint –
Quick Connector.
Using your full weight,
push the child restraint
firmly into the vehicle
seat while pulling up on
the lower anchor strap
to tighten, as shown.
IMPORTANT: To properly secure this child restraint, it
MUST NOT move more than 25 mm (1 inch) from side to
side or front to back at the forward-facing belt path.
If you cannot tightly secure the child restraint, try again or
move it to another location.
IMPORTANT: To properly secure this child restraint, it
MUST NOT move more than 25 mm (1 inch) from side to
side or front to back at the forward-facing belt path.
If you cannot tightly secure the child restraint, try again or
move it to another location.
Recline Positions Rear-facing use ONLY 1
Forward-facing 10 - 18 kg (22-40 lbs) when using Harness Straps 3
2
Forward-facing 10 - 29.4 kg (22 - 65 lbs) when using Harness Straps AND in Booster Mode 18 - 49.8 kg (40 - 110 lbs) Arrow must be level with ground when child restraint is used rear-facing.