Evenflo Symphony 65 - Manual (Page 13)

1. Remove lower an-
chor connectors
from the forward-
facing belt path.
Reach through the
harness straps and
remove each lower anchor
connector, one at a time.
2. Place each lower
anchor connector
in the rear-facing
belt path.
3. Make sure the
crotch buckle as-
sembly is posi-
tioned in front of
the lower anchor
connector assem-
bly, as shown.
Note: Do not forget to install the seat pad before installing
the child restraint in your vehicle.
Moving Lower Anchor Connector
Assembly to Rear-facing Belt Path
22 23
1. Place the child
restraint in position.
Adjust the child restraint
to the most reclined
position (
Recline Position
#1, p. 53), then place it on
the vehicle seat in the rear-
facing position, as shown.
Recline Positions Rear-facing use ONLY 1 Forward-facing 10 - 18 kg (22-40 lbs) when using Harness Straps 3 2 Forward-facing 10 - 29.4 kg (22 - 65 lbs) when using Harness Straps AND in Booster Mode 18 - 49.8 kg (40 - 110 lbs) Arrow must be level with ground when child restraint is used rear-facing.
2. Attach lower anchor connectors.
Push a lower anchor connector onto each vehicle
lower anchor bar.
Note: You may need to vary the angle of the lower an-
chor connectors, as shown above, to attach to the lower
anchor bar. Also, make sure the lower anchor connector
assembly is in the rear-facing belt path (p. 21).
Far side
Recline Positions Rear-facing use ONLY 1
Forward-facing 10 - 18 kg (22-40 lbs) when using Harness Straps 3
2
Forward-facing 10 - 29.4 kg (22 - 65 lbs) when using Harness Straps AND in Booster Mode 18 - 49.8 kg (40 - 110 lbs) Arrow must be level with ground when child restraint is used rear-facing.
Lower Anchor Bar
Near Side
IMPORTANT:
• If you are using the vehicle seat belt to secure the child
restraint, DO NOT use lower anchor connectors.
• DO NOT use the tether strap when the child restraint is
in the rear-facing position .
Rear-facing Installation with Lower
Anchor Connectors
IMPORTANT: Make sure both SureLatch connectors or Quick
Connectors are facing upward and the straps are not twisted.
Strap
Correct Incorrect
SureLatch
Quick Connector
Rear-facing
Lower Anchor
Bar
IMPORTANT: Make sure
the lower anchor connector
assembly does not interfere
with the internal harness
straps.