Oven control – Amana ART6002 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OFF
OVEN
BROIL
WM
Oven Control
TIMER Pad
Selects timer feature. Timer can be set up to 11 hour 59 seconds. Timer does not control
oven operation.
TIMER pad has light that flashes when timer is being set and glows when timer is counting
down.
CLOCK Pad
Press to set clock and turn clock display on and off.
HRS Pads
Increases or decrease time by hours.
MIN Pads
Increase or decrease time by minutes.
OVEN Light
Glows when oven is on. Light flashes after self-clean cycle turns off as a reminder to turn
temperature knob to OFF.
LOCKED Light
Glows when oven door is locked and oven is set for self-cleaning. After self-clean cycle,
light flashes. Unlatch oven door and turn temperature knob to OFF.
PREHEATED
Light
Glows when oven reaches selected temperature.
Temperature
Knob
Controls oven temperature, self-clean, and broil. Push-to-turn knob prevents accidentally
turning oven on.
Time Display
Shows the time-of-day and timer minutes.
Timer light allows the user to identify timer mode quickly and easily.
other Features
12-hour automatic
cancel
As a safety feature, oven control automatically shuts off oven after 12 hours of operation.
This feature can be turned on or off.
To allow the oven to operate for more than 12 hours, confirm temperature knob is in OFF
position. Then, press and hold the MINS + and - pads for approximately
4 seconds. Display will change from time-of-day, show “OFF”, and then return to time-of-
day.
To set oven to shut off after 12 hours, confirm temperature knob is in the OFF position.
Then, press and hold the MINS + and - pads for approximately 4 seconds. Display will
change from time-of-day, show “ON”, and then return to time-of-day.
Service codes and
tones
Electronic oven control is equipped with a self diagnostic system. Self diagnostic system
alerts you if there is an error or problem in the control. If the range control sounds a series
of short, rapid beeps for over 16 seconds and display shows a F-code, record the F-code
shown. Some F-codes can be cleared by disconnecting power to the range. If the code
continues to reoccur call an authorized servicer. Disconnect electrical supply to range and
contact an authorized servicer.
F2—High Oven Temperature
F3—Temperature Sensor Malfunction
F4—Temperature Sensor Malfunction
14