Zapco Studio X Series User Manual

Page 5

ST-2X Output

1. LED Indicators let you know the status of the amplifier. The green LED

tells you the amp is on. The Red LED lets you know the amp is in
“protection” because of some problem with the system.

2. Fuse The fuse protects the car should a catastrophic problem occur in the

amp. Always replace with the same size fuse

3. Speaker connections The heavy duty terminal block provides positive

speaker connections. Simple insert the wire and cinch down the set
screw. Note that the Mono bridge positions here are L

to R

4. GND The amp should have a firm connection the car frame. * See sec-

tion

"Install Sense"

5. REM The remote terminal connects to the head unit remote out, or to

some other switched 12 volt source to turn on the amplifier.

6. +12V The main 12 volt must be connected directly to the vehicle’s battery

using wire of the proper gauge. * See section

"Install Sense"