StarTech.com ST121SHD50 - Manual (Page 10)

Instruction Manual
7
EDID Factory Default Setting
To avoid confusion in which EDID information has been copied or for more purposes,
this function enables to reset the state to factory default.
Step 1. Use CATx cable for connection between Tx & Rx on Aux RJ-45 Jack. Apply
power to Receiver Unit.
Step 2. Press the button “EDID Copy” and release the button RIGHT AFTER the LED
flashes red.
Step 3. The LED flashes green & red indicating default setting successfully.
DDC Pass Mode
Press the button for more than 15 sec. and release right after the LED flashes green.
The LED lights blue indicating setting successfully. To exit this mode, follow “EDID
Factory Default Setting” steps.