SIG SAUER P250 Sight Adjustment Tool - Manual

CONTACT
18 Industrial Drive, Exeter, NH 03833 • (603) 772-2302 • www.sigsauer.com
PN 8500175 REV 1.0
INSTRUCTIONS fOR USe
The SIG SAUER ® P250 Sight Tool will work on the P250 series
of pistols. This tool facilitates windage adjustment, removal
and installation of the P250 front sight for all caliber and slide
configurations. Different front sight heights are available for
elevation adjustments.
This tool is not for use with the P250 rear sight. The P250 rear
sight is not drift adjustable – all windage adjustments take place
with the front sight. The P250 rear sight can be replaced to
accommodate elevations adjustments outside the range of front
sight replacement. See the P250 Operators Manual that shipped
with your pistol for more information.
WARNING: Sight manipulations should ONLY be performed on
an unloaded firearm. Serious injury or death could occur if sight
manipulation is attempted on a loaded firearm.
P250 SIGHT TOOL
To adjust front sight:
1. Center adjustment head above the sight tool
window.
2. Install the slide on the locking plate through the
front side of the tool.
3. Push the slide inward until the back of the spring
box makes contact with the spring box cutout in
the tool.
4. Depending upon the direction of desired sight
adjustment, move the slide right or left until it
bears against the slide rest (rounded face above
the angled surface of the spring box cutout) and
tighten the locking plate screw.
5. Turn the handle to adjust the front sight in the
desired direction.
To install front sight:
Note: Sight replacement should only be performed
by a certified armorer or someone with the proper
training.
1. Install the front sight from the left side of
the slide, as viewed from the rear (“shooters
perspective”)
2. Proper alignment of the sight in the slide dovetail
is required to prevent sight damage during instal-
lation. SIG SAUER recommends using a small
amount of lubrication in the slide dovetail to
ease installation. Seat the sight base in the slide
dovetail by lightly tapping the sight with a small
hammer before inserting in the sight tool.
3. Follow steps 3 thru 5 “front sight adjustment”.
Ensure the adjustment head is
correctly aligned with the front sight prior to fully
seating the slide in the sight tool.
Maintenance: There are no special lubrication or maintenance steps for this product. Oil impregnated
bronze bushings have been incorporated at both sides of the tool resulting in less vertical play, increasing
the smoothness of operation, and eliminating the need for oiling both ends of the shaft prior to each use.
SIG SAUeR ® LIMITeD ONe YeAR WARRANTY
SIG SAUER ® warrants that the enclosed accessory was originally manufactured free of defects in material, workmanship and
mechanical function, and agrees to correct these defects by repair, adjustment or replacement, at the option of SIG SAUER, with
items of the same or comparable quality; provided, however, that the accessory is returned freight prepaid to SIG SAUER at 18
Industrial Drive, Exeter, NH 03833 by the original purchaser within one year of the date of purchase.
This limited warranty is null and void if the accessory has been misused, damaged (by accident or otherwise), or if unauthorized
repair or any alteration, including of a cosmetic nature, has been performed on the accessory. This limited warranty does not apply
to normal wear and tear of any parts.
Subject to the foregoing, this limited warranty confers the right to have the covered accessory or its parts repaired, adjusted or
replaced exclusively by the original purchaser, which right is not transferable to any other person. NO IMPLIED WARRANTIES OF ANY
KIND, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE MADE HEREIN, and this
warranty does not apply to any accessory items attached or appurtenant to this accessory. In no event shall SIG SAUER be liable for
incidental or consequential damages arising from or in connection with this limited warranty.