SeaShell SS-i5 User Manual User Manual
Page 7
- 6 -
2.6. Unloading iPhone from Seashell housing
a. Rinse the Seashell housing with tap water
thoroughly while the iPhone is still inside the
Seashell housing
b. Completely dry the Seashell housing with cloth or
paper towel.
c. Open the Seashell housing by lifting the sliding
knob at the lock.
d. Unload the iPhone from the housing.
e. If the housing is difficult to open, swing the lock
all the way to the rear housing. The tag at the lock
can push against the front housing and make the
housing easier to separate.
2.7. Water Leakage
a. In case water leak is observed while using the Seashell housing, stop
using it, and remove it from water as quickly as possible.
b. Failure to do so may cause an electrical or fire hazard. The iPhone may
also be damaged.
c. Immediately wipe with a cloth or tissue paper to dry off the iPhone and the
inside of the housing. Inspect and apply necessary maintenance.
2.8. Maintenance of main O-ring
a. Keep the main O-ring clean, as a dirty O-ring may
cause leakage.
b. When the O-ring becomes dirty, by hand, remove
the O-ring from the slot of the Seashell housing.
Avoid using sharp tools which may damage the
O-ring.
c. Do not over-stretch the O-ring as it may cause
damage.
d. Clean the O-ring by flushing tap water, and gently
remove the dirt with your fingers.
e. Apply one drop of O-ring grease and spread it
along the whole length of the O-ring using your
fingers pulling from one direction until the entire
O-ring is coated with O-ring grease, as shown.
f. Applying too much O-ring grease may cause
leakage.
g. Never use any other grease not supplied by Zear
Corporation Ltd.
h. Do not use paper towel or cloth to apply O-ring grease, use your fingers only.
i. Gently put the lubricated O-ring by hand back into the O-ring grove at the
rear housing.
j. Clean and lubricate the main O-ring periodically to ensure best
performance.
k. Replace the O-ring annually.
l. Clean all dirt or sand at the O-ring grove with tissue paper before
putting the O-ring back if required.