Intex SF60110 2014 - Manual (Page 8)

195
PO
SAVE THESE INSTRUCTIONS
(195PO) SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
English
Page 8
PRODUCT SPECIFICATIONS
SETUP INSTRUCTIONS
NOTE: NOT SUITABLE FOR USE WITH KCP-LOW -SALT AUTOMATIC SALTWATER
SYSTEM (MODEL 6110/6220)
The sand filter removes suspended particles but does not sanitize your pool. Pool chemistry
is a specialized area and you should consult your local pool service specialist for details.
TOOLS REQUIRED: One (1) Phillips screwdriver
Pump location and mounting:
• The system must be installed on a solid level and vibration-free base.
• Provide a location protected from the weather, moisture, flooding and freezing
temperature.
• Provide adequate access, space and lighting for routine maintenance.
• Pump motor requires free circulation of air for cooling. Do not install the pump in a
damp or non-ventilated location.
A team of 2 or more people is recommended for setting up this product.
Motor pre-filtering assembly setup:
1. Remove the sand filter and its accessories from the packaging carefully and inspect for
any visible damage. For missing or damaged parts contact the appropriate Intex Service
Center listed in the separate “Authorized service Centers” sheet.
2. In a counter-clockwise motion unscrew the leaf trap cover (14) from the pre-filter housing.
Take out the basket (16) and filter housing nut (17) (see drawing 10).
3. Connect the pre-filter housing to the motor water inlet. Note: Align the connector in the
pre-filter housing with the water inlet on the motor (see drawing 11).
11 10
35
17
16
14
Model: SF80110 SF70110 SF60110
Power: 110-120 Volt AC 110-120 Volt AC 110-120 Volt AC
Amperage: 3 A 4.8 A 6 A
Maximum working pressure: 2 bar (30 psi) 2 bar (30 psi) 2 bar (30 psi)
Effective filtering area: 0.07 m 2 (0.79 ft 2 ) 0.1 m 2 (1.07 ft 2 ) 0.13 m 2 (1.44 ft 2 )
Maximum Flow Rate: 6055 LPH (1600 GPH) 8140 LPH (2150 GPH) 9275 LPH (2450 GPH)
Recommended filtering
media quantity: No. 20 silica sand
23 Kg (50 Lbs) or
glass sand 16 Kg
(35 Lbs). No. 20 silica sand
35 Kg (77 Lbs) or
glass sand 25 Kg
(55 Lbs). No. 20 silica sand
55 Kg (121 Lbs) or
glass sand 38 Kg
(84 Lbs).
Recommended filtering
media (Not included): No. 20 silica sand or glass sand. Particle size range 0.45 to 0.85
mm (0.018 to 0.033 inches). Uniformity Coefficient less than 1.75.
Limited Warranty: see “Limited Warranty”