Save these instructions, Sand filter pump hose connection setup (continued) – Intex SF60110 2014 User Manual
Page 13

195
PO
SAVE THESE INSTRUCTIONS
(195PO) SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
English
Page 13
SAND FILTER PUMP HOSE CONNECTION SETUP (continued)
For INTEX pool size 16' and below:
1. In a counter-clockwise motion unscrew plunger valve union from the threaded strainer
connector (26). Be careful not to lose the step rubber washer (23).
2. Grasp the plunger valve assembly. Make sure the step washer (23) is in place.
Connect adaptor B (28) to plunger valve union.
3. Remove wall plug and then insert the strainer (29 & 31) into the lower position of
protruding hose connection, and the nozzle (29 & 30) into the upper position of
protruding hose connection. Adaptor B (28) fits over the strainer connection (29)
inserted into the connection. Tighten securely.
4. Remove the drain cap (3) before attaching the drain/waste hose or pipe.
For NON-INTEX pool:
Connect the hose (12) to the pool inlet/outlet connection with a large hose clamp. Tighten
securely. Remove the drain cap (3) before attaching the drain/waste hose or pipe.
POOL
LARGE HOSE
CLAMP
12
3
POOL
29 & 30
29 & 31
3