Intex 635T Krystal Clear 2011 User Manual

Page 14

107

SAVE THESE INSTRUCTIONS

Page 14

(107) MODEL 635T FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U

07/16/2010

English

TROUBLESHOOTING GUIDE

IINN

IIDD

• Filter cord must be plugged into a 3 wire

outlet that is protected by a Class A
Ground Fault Circuit Interrupter.

• Reset circuit breaker. If circuit breaker trips

repeatedly, your electrical system may
have a defect. Turn off circuit breaker and
call an electrician to correct the problem.

• Let motor cool down.

• Adjust the chlorine and pH level. Consult

your local swimming pool supply stores.

• Clean or replace cartridge.
• Check the cartridge for holes. Replace if

damaged.

• Operate the filter for longer periods.
• Clean the strainer screen at the inlet.

• Clear any obstructions in the intake hose

by discharging it inside pool wall.

• Tighten hose nuts, check hoses for

damage, check pool water level.

• Clean cartridge more often.
• Clean inside the plunger valve.
• Pull valve handle to full upright position.
• Install the nozzle at the upper position of

the pool inlet, and the strainer at the lower
position of the pool outlet.

• Fill pool to correct water level.
• Clean strainer screens at pool inlet.
• Tighten hose nuts, check hose for damage.
• Clear any sticks or leaves in the intake

hose.

• Turn and pull valve handle to full upright

position.

• Remove cover & check for O-ring.
• Tighten cover (Manually).
• Replace or clean cartridge.

• Tighten or reinstall hose nut.

• Open air release valve, wait until water

starts to flow out of the air release valve,
close air release valve.

• The lower position of pool outlet connects

to filter pump water inlet. The upper
position of pool inlet connects to filter
pump water outlet.

FILTER MOTOR
FAILS TO START

FILTER DOESN’T
CLEAN POOL

FILTER DOESN’T
PUMP WATER OR
THE WATER FLOW
IS VERY SLOW

PUMP DOESN’T
WORK

TOP COVER
LEAKING

HOSE LEAKING

AIR LOCK

• The motor is not plugged in.
• The fuse box needs

checking.

• The GFCI circuit breaker is

tripped.

• Motor too hot and overload

protection shut motor off.

• Improper chlorine or pH

levels.

• Filter cartridge is dirty.
• Damaged cartridge.
• Excessively dirty pool.
• The strainer screen is

restricting the water flow.

• Clogged inlet or discharge.
• An air leak on the intake line.
• Scale or buildup on

cartridge.

• Excessively dirty pool.
• Dirty filter cartridge.
• The nozzle and strainer

connection are reversed.

• Low water level.
• Strainer screen plugged up.
• An air leak on the intake hose.
• Faulty motor or the impeller

is jammed.

• An air lock inside the

cartridge chamber.

• O-ring missing.
• Cover is not tight.
• Filter cartridge is dirty.

• Hose nuts are not well-fitted.

• There’s air trapped in the

pump housing and inlet
hose.

• The inlet and outlet hoses

connection are reversed.

TROUBLE

CAUSE

SOLUTION

IMPORTANT

If you continue to experience difficulty, please contact our Consumer
Service Department for assistance. See back cover for contact information.