beautypg.com

Intex 635T Krystal Clear 2011 User Manual

Page 10

background image

107

SAVE THESE INSTRUCTIONS

Page 10

(107) MODEL 635T FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U

07/16/2010

English

OO

PP

EE

RR

AA

TT

IINN

GG

II

NN

SS

TT

RR

UU

CC

TT

IIOO

NN

SS

1.

Make sure the filter pump is switched off. The switch is located on the motor
housing.

2.

Connect the power cord to a GFCI protected electrical outlet.

3.

Grasp a plunger valve handle. Turn the handle counter-clockwise, pull up until
it stops, and then turn it clockwise until the metal protruding notch anchors in
the "0/1" position. Repeat for the second plunger valve. This opens the valves,
allowing water to flow into the filter pump.

4.

With water flowing into filter pump, the water pressure will allow the air trapped
inside to escape from the air release valve (2). When all the air has escaped
water will flow out of the valve (2). When this occurs gently finger tighten the
valve (2) in a clockwise direction.

5. To operate the filter pump on “TIMER” mode:

A. Set the timer dial to the desired operating hours. See operation time table.

See Fig. 10

B. Turn on the pump by pressing the switch to “ ” position, the filter pump is

now filtering the water and will stop after the operating hours are
completed. The built-in timer will now operate for the number of hours
selected at the same time each day.

C. Operating hours can be re-adjusted if necessary. Follow step A – B.
To operate the filter pump manually (without the “TIMER” mode):
A. Turn on the pump by pressing the switch to “-” position, the filter pump is

now filtering the water.

B. To turn off the pump, press the switch to “O” position.

Risk of electric shock. Connect this product only to a grounding type
receptacle protected by a ground-fault circuit interrupter (GFCI). Contact a
qualified electrician if you cannot verify that the receptacle is protected by
a GFCI.

WARNING

OPERATING INSTRUCTIONS

To prevent air lock, open the lower plunger valve (connected inlet hose)
first and then the upper plunger valve (connected outlet hose). Open the
air release valve, wait until water starts to flow out of the air release valve,
close air release valve.

IMPORTANT

2

4

6

8

12

ON

OFF TIMER

FIG 10

TIMER DIAL (HOURS)