Bullet Tools RCT 520 - Manual (Page 5)

4
SEt Up
3. ATTACH TAblE
A. Attach front of table to base,
using item D screws. Tighten
with #3 Phillips.
B. Attach back of table to tail using
item e self tapping screws.
Tighten with #2 Phillips.
4. TO ATTACH HANDlE:
Insert item F screws and tighten with 1/2”
(13mm) wrench.
Note: To ensure correct alignment, start each of
the bolts by hand before using wrench.
5. ATTACH ANGlE GUIDE
Install angle guide and tighten Item G thumbscrew.
3
4
3b
3A
item e
item D
item F
Tail
item G
5