AquaCraft SuperVee 27 Nitro - Manual (Page 4)

4
TRANSMITTER ASSEMBLY
Note: The transmitter is not water resistant and should
never come in contact with water.
❏
1. Remove the transmitter antenna from the plastic bag
located on the back of the cardboard transmitter protector.
Screw the antenna into the hole located at the top of the
transmitter. Give a light tug on the antenna to make sure it
is threaded in properly.
❏
2. Slide the battery door open on the bottom of the
transmitter and install eight (8) fresh “AA” batteries. Follow
the diagram located in the bottom of the battery tray for
proper battery orientation.
❏
3. Turn the transmitter “ON”. The battery light should
glow bright red. If the light does not turn on re-check the
installation of the batteries.
INSTALL THE RECEIVER ANTENNA
❏
1. Locate and turn the rear hatch lock 1/4 turn to unlock
and remove the hatch.
❏
2. Install the receiver antenna tube by pushing lightly
into the plastic antenna base as shown.
INSTALL THE RECEIVER BATTERIES
❏
1. Open the radio box lid and install four fresh “AA”
batteries in the battery holder. Be sure to follow the
polarity confi guration molded into the battery holder.
❏
2. Plug the battery box connector into the ON/OFF
switch connector. Do not force them together; they are
designed to fi t together only one way.
❏
3. Replace the radio box lid and secure it with the latches
located on both sides of the radio box.