AquaCraft Reef Racer 2 - Manual (Page 4)

❏
5. The canopy is held to the deck of the Reef Racer 2 with
hook & loop material. Open the battery compartment of the Reef
Racer 2 by gently lifting the canopy as shown.
❏
6. Each hatch lid is held in place by tabs. Twist the forward
lid until the tabs line up with the slots and gently lift the lid
from the deck as shown.
❏
7. Plug the battery pack into the boat’s battery connector.
Do not force them together; they are designed to fit together
only one way. Place the battery pack in the battery tray with
the provided hook & loop material as shown.
❏
8. Replace the forward hatch lid with the tabs lined up
with the slots and give it a twist to lock it in place.
CHECK OPERATION:
❏
1. Turn the power “ON” to the transmitter and then the boat
(in that order). Place the canopy on top of the Reef Racer 2 hull
and make sure that the hook & loop material attach securely.
❏
2. Standing behind the boat with both the Reef Racer 2 and
transmitter “ON”, rotate the wheel to the left. The back of the
rudder should move towards the left. Move the wheel to the
right. The back of the rudder should move towards the right.
❏
3. Squeeze the trigger on the transmitter, the propeller
should turn in a counter-clockwise motion.
❏
4. Turn the power “OFF” to your boat and then
your transmitter.
• NEVER attempt to swim after a stalled or capsized boat!
Wait patiently for the wind currents to return the boat to
shore or use a tennis ball attached to the end of a fishing
rod to retrieveit.
• It is dangerous to operate any R/C vehicle at any time that
there is insufficient light.
PLEASE READ BEFORE RUNNING
THE REEF RACER 2
4