AquaCraft Paradise - Manual (Page 6)

❏
2. Attach the forestay and backstay to their corresponding
eyelets as shown. The numerical markings in the photos may
not match those of your model.
❏
3. Tighten the lines by adjusting the adjustment blocks
(bowsies) as shown. It is important to make sure that the mast
is as straight as possible.
❏
4. Attach the remaining snap rings to their counterparts
and tighten all of the lines. Once again, make sure that the
mast stands as straight as possible.
CHECKING THE RADIO SYSTEM, RUDDER INSTALLATION,
AND ATTACHING THE SAIL CONTROL LINES
❏
1. Turn the power “ON” to the transmitter and sailboat (in
that order).
❏
2. Move the sail control stick (left stick) all the way down
and center both the left and right trims.
❏
3. Gently twist the helm pedestal and lift the rear hatch
from the deck as shown. This will enable you to access the
rudder pushrods and rudder control arm.
❏
4. Insert the rudder shaft up through the small hole at stern.
The rudder is shaped so that it will only fit one way.
6